Gyration GP3200 User Manual

When two devices are being used in the same proximity, each 

device should be set to operate on a unique channel. For the 

best reception, space the channels apart by one or more chan-

nels. For example, setting the channels to “2” and “4” is rec-

ommended over setting the channels to “2” and “3”.
If you are installing three or more devices on a single receiver, 

see “Installing 3 or More Devices” on page 9. Remember if a 

Teach/Learn sequence has already been performed, it is not 

necessary to re-synchronize the devices after a channel 

change.
To change the channel: 
1. Press and hold the Channel button on the back of the 

keyboard for two seconds. 

When you release the Channel button, the keyboard will 

change to the next sequential channel and the green LED 

light on the front (or the back) of the keyboard will flash. 

The number of flashes indicates the new channel the key-

board is using.

It is not necessary to power down the keyboard when it is idle. 

However, it is recommended you power down when traveling 

to avoid inadvertent key presses that may occur.
 To power on:

„

Simultaneously press and release the Channel and 

Teach buttons on the back of the keyboard for three 

seconds. It will confirm it is powering on by flashing its 

LED light for one second.

To power off:

„

Simultaneously press and release the Channel and 

Teach buttons on the back of the keyboard. It will 

immediately power off and be unresponsive to button 

clicks. It will confirm it is powering off by flashing its LED 

light three times.