Pelco KBD4000 User Manual
26
Pelco Manual C1921M-G (1/04)
MULTIPLE CAMERA DISPLAY SETUP
You can use the keyboard to configure multiple camera display formats. The LEDs above
the camera buttons on the multiplexer light to indicate which cameras are being displayed.
the camera buttons on the multiplexer light to indicate which cameras are being displayed.
PROGRAMMING THE PICTURE-IN-PICTURE DISPLAY (
)
You can program the on-screen location and size of the picture-in-picture (PIP) display. PIP
is unavailable in duplex VCR playback and in simplex record mode.
is unavailable in duplex VCR playback and in simplex record mode.
To program the PIP display:
1.
Press the MAIN MONITOR key.
2.
Use the number pad to enter the multiplexer’s address (1-16 if the keyboard is
connected to a multiplexer; 1-8 if the keyboard is connected to a server), and then
press the UNIT key.
connected to a multiplexer; 1-8 if the keyboard is connected to a server), and then
press the UNIT key.
3.
Press the
key.
4.
Press the
key for about three seconds until the message PROGRAM PIP SIZE
appears.
5.
Use the joystick to increase or decrease the PIP display size.
6.
Press the
key for about three seconds until the message PROGRAM PIP
POSITION appears.
7.
Use the joystick to move the PIP display location.
8.
Press and hold the
key to exit the PIP programming menu.
PROGRAMMING THE 4-CAMERA DISPLAY (
)
You can program four groups of four cameras each. Each of the four groups can be
programmed to include any four cameras.
is unavailable in simplex record mode.
To program the four-camera displays:
1.
Press the MAIN MONITOR key.
2.
Use the number pad to enter the multiplexer’s address (1-16 if the keyboard is
connected to a multiplexer; 1-8 if the keyboard is connected to a server), and then
press the UNIT key.
connected to a multiplexer; 1-8 if the keyboard is connected to a server), and then
press the UNIT key.
3.
Press the
key to call up a four-camera display. If necessary, press the
key
again to advance to the four-camera group you wish to configure.
4.
Press the
key for about three seconds. A bar appears in the first camera location
of the four-camera display, indicating that you are in programming mode.
5.
Use the joystick to move to each camera location in the four-camera display.
6.
When the camera location you desire is highlighted, choose the new camera by
pressing the number key for the desired camera and then pressing the CAM key.
pressing the number key for the desired camera and then pressing the CAM key.
7.
To exit programming mode, use the joystick to move the bar off the screen.
8.
If necessary, repeat steps 1-7 to program another group.