Sony SAC7000 User Manual

When you pan a track using the pan slider or a pan envelope, you can choose among several pan types to determine how the track is 
panned. 

Click the pan slider label and choose a pan type from the submenu: 

•

The Add Channels pan type is most useful for panning stereo source material. This pan type makes the stereo image appear 
to move as a unit between the speakers. As the fader is moved from the center to a side, more and more of the signal from the 
opposite side is folded into the side you are panning towards, until at the extreme, both channels are fed at full intensity into 
a single channel. This pan type uses a linear panning curve. 

•

The

 

Balance pan type is most useful for adjusting the relative signal levels of the right and left channels in stereo source 

material. In this pan type, moving from the center to a side, the opposite side starts at a base dB level (either 0 dB, -3 dB, or ­
6 dB) and decays to no signal level. The signal in the side you are panning towards starts at the base dB level (either 0 dB, -3 dB, 
or -6 dB) and increases to 0 dB. When the stereo source is panned fully to one side, that side plays at 0 dB while the other side 
provides no signal at all. This pan type uses a linear panning curve. 

•

The

 

Constant Power pan type is most useful for panning mono source material. As you move the fader from side to side, this 

pan type creates the illusion of the source moving around the listener from one side to the other, in a semi-circle. This pan 
type uses the constant-power panning curve. 

•

The

 

Film pan type allows you to pan between pairs of adjacent speakers using a constant power model. This mode is 

optimized for theater-style speaker placement. In stereo projects, Film mode functions identically to Constant Power. As you 
drag the pan point to the center speaker, the sound becomes diffused through the front and rear speakers. When the track is 
panned fully to the center speaker, there is no output from the front and rear speakers. Dragging the pan point to the center of 
the surround panner sends the signal to all speakers. 

You can choose a pan type as a default for all new tracks you create. For more information, see 

When a long file is added to a project, the Beatmapper Wizard starts to allow you to add tempo information to the file. 

•  The Beatmapper Wizard is started by default for files longer than 30 seconds. Use the Open files as loops if between (seconds) setting 

Perform either of the following actions to start the Beatmapper Wizard: 

•

Add a long file to your project. If tempo information is not detected in the file, the Beatmapper Wizard starts. 

Select the Yes radio button and click Next to detect measures and downbeats. The file will be able to stretch/compress with 
the project's tempo. 

Select the No radio button and click Finish if you want to add the file as a one-shot. The file will maintain its original length 
regardless of the project tempo.

—or—

•

Open the Clip Properties window for a Beatmapped track, switch to the Stretch tab, and click the Beatmapper Wizard button. 

The Beatmapper Wizard will draw the file's waveform and place a marker to locate the first beat of the first measure. 

Click the Play button ( 

) to verify the marker’s position. If the marker is positioned on a downbeat, click Next. Otherwise, drag the 

marker to the appropriate location and click Next. 

 Click the Reset button to set the downbeat marker to its original position. 

The Beatmapper Wizard will draw the file's waveform and place a region to indicate the length of the first measure. 

WORKING WITH TRACKS 

|