Symantec 5 User Manual
Figure 7-1
Adding a node to a two-node cluster using two switches
Public network
Private
network
network
New node:
saturn
saturn
To set up the hardware
1
Connect the VCS private Ethernet controllers.
Perform the following tasks as necessary:
■
When you add nodes to a two-node cluster, use independent switches or
hubs for the private network connections. You can only use crossover
cables for a two-node cluster, so you might have to swap out the cable for
a switch or hub.
hubs for the private network connections. You can only use crossover
cables for a two-node cluster, so you might have to swap out the cable for
a switch or hub.
■
If you already use independent hubs, connect the two Ethernet controllers
on the new node to the independent hubs.
on the new node to the independent hubs.
illustrates a new node being added to an existing two-node cluster
using two independent hubs.
2
Connect the system to the shared storage, if required.
Preparing for a manual installation when adding a node
Before you install, log in as the superuser. You then mount the disc and put the
files in a temporary folder for installation.
files in a temporary folder for installation.
123
Adding and removing cluster nodes
Adding a node to a cluster