HP (Hewlett-Packard) RX3600 User Manual
NOTE:
Assembly side 0 is on the left, and assembly side 1 is on the right as viewed from
the front of the chassis.
3.
Slide the memory carrier assembly into the chassis until it begins to seat into the socket
located on the processor board.
located on the processor board.
CAUTION:
Do not apply excessive force when closing the extraction handles and seating
the memory carrier assembly into the socket on the processor board. Manipulate the extraction
handles with care; failure to observe these cautions can result in damage to the extraction
handles and other server components.
handles with care; failure to observe these cautions can result in damage to the extraction
handles and other server components.
4.
Rotate the extraction handles inward and press the handles straight down until they snap
into the locked position.
into the locked position.
5.
Replace the memory carrier assembly cover and latch the top cover release lever closed. See
6.
If rack installed, slide the server completely into the rack. See
7.
Reconnect the power cables and power on the server. See
Removing and Replacing System Memory
System memory, or DIMMs, are located on a pair of memory boards inside the memory carrier
assembly.
assembly.
WARNING!
Ensure that the system is powered off and all power sources have been disconnected
from the server prior to performing this procedure.
Voltages are present at various locations within the server whenever an ac power source is
connected. This voltage is present even when the main power switch is in the off position.
connected. This voltage is present even when the main power switch is in the off position.
Failure to observe this warning can result in personal injury or damage to equipment.
CAUTION:
Observe all ESD safety precautions before removing or replacing system memory.
Failure to follow ESD safety precautions can result in damage to the server.
Removing System Memory
To remove system memory, follow these steps:
1.
Power off the server and disconnect the power cables. See
2.
If rack installed, slide the server out from the rack until it stops. See
3.
Unlatch the cover release lever on the top cover and remove the memory carrier assembly
cover. See
cover. See
NOTE:
You do not need to fully remove the top cover to service this component; however,
the top cover release lever must be open. You must remove the memory carrier because it
attaches directly to the processor board.
attaches directly to the processor board.
4.
Remove the memory carrier assembly. See
206
Removing and Replacing Server Components