HP (Hewlett-Packard) RX3600 User Manual

Syntax

baud <index> <baudrate>

Parameters

<index> 0 through the total number of UARTS minus one
<baudrate>      baud rate.

Operation

Use this command to change the speed for a UART in the system. This command works for all
UARTs visible to EFI/POSSE. If the UART is part of processor dependent hardware (PDH) space
and is initialized by the core firmware, this command communicates the settings to core firmware
so the UART can be initialized with the new settings on the next boot.
System default is 9600 baud.
Other communication parameters are listed in

Table D-2 Communications Parameters

Value

Parameter

1

RECEIVE_FIFO_DEPTH

1000000

TIMEOUT

No parity

PARITY

8

DATA_BITS

1

STOP_BITS

0

CONTROL_MASK

boottest

Interacts with the speedy boot variable enabling it to be set appropriately.

Syntax

boottest                        Displays status of all speedy boot bits
boottest on                     Run all tests (for a normal boot time)
boottest off                    Skip all tests (for a faster boot time)
boottest [test]                 Displays status of specific Speedy Boot bit
boottest [test] [on off]        Sets or clears a specific Speedy Boot bit

Parameters

[test]  Each test can be set or cleared: 
        booting_valid   Enable/disable system firmware response to BOOTING
                        bit. If OS Speedy Boot aware set to on.
        early_cpu       Enable/disable early CPU selftests.
        late_cpu        Enable/disable late CPU selftests.
        platform        Enable/disable system board hardware tests.
        chipset         Enable/disable CEC tests.
        io_hw           Enable/disable EFI driver Core I/O tests.
        mem_init        Enable/disable memory initialization.
        mem_test        Enable/disable full destructive memory tests.

EFI/POSSE Commands

323