Emerson PMPPC7448 User Manual
Monitor:
Other Commands
11-18
diags
The diags command runs the Power-On Self-Test (POST).
DEFINITION:
diags
mtest
The mtest command performs a simple SDRAM read/write test.
DEFINITION:
mtest [start [end [pattern]]]
um
The um command is a destructive memory test. The test will repeat indefinitely unless the
‘q’ key is pressed. The test must complete its current testing cycle before acknowledging
the request to quit.
‘q’ key is pressed. The test must complete its current testing cycle before acknowledging
the request to quit.
DEFINITION:
um [.b, .w, .l] base_addr [top_addr]
OTHER COMMANDS
This section describes all the remaining commands supported by the PmPPC7448 monitor.
autoscr
The autoscr command runs a script, starting at address addr, from memory. A valid autoscr
header must be present.
header must be present.
DEFINITION:
autoscr [addr]
base
The base command prints or sets the address offset for memory commands.
DEFINITION:
Displays the address offset for the memory commands.
base
Sets the address offset for the memory commands to off.
base off
bdinfo
The bdinfo command displays the Board Information Structure.
DEFINITION:
bdinfo
coninfo
The coninfo command displays the information for all available console devices.