Promise Technology J610s User Manual
51
Appendix A: Second I/O Module
The VTrak J610s and J310s units ship with one or two I/O modules. If your J610s
or J310s came with only one I/O module, you can upgrade by installing a second
I/O module. The following instructions describe how to install a second I/O
module.
or J310s came with only one I/O module, you can upgrade by installing a second
I/O module. The following instructions describe how to install a second I/O
module.
To install a second I/O module in a VTrak J610s or J310s unit:
1.
1.
Power down the J610s or J310s unit.
2.
Press the release button on the dummy I/O module, pull the handle down
and remove the dummy I/O module from the enclosure.
and remove the dummy I/O module from the enclosure.
3.
Slide the new I/O module into the slot.
4.
Gently push the new I/O module all the way into the slot until the handle
locks.
locks.
5.
Connect your data cables to the new I/O module.
See page 20 for more information.
See page 20 for more information.
6.
Optional. Connect your serial cable to the second I/O module.
See page 25 for more information.
See page 25 for more information.
7.
Power up the J610s or J310s unit.
To verify proper installation and function, run the enclosure command in the CLI.
Because the new I/O module is installed in the right slot, it will automatically take
the Standby role in the CLI screen. See page 34 for more information.
Because the new I/O module is installed in the right slot, it will automatically take
the Standby role in the CLI screen. See page 34 for more information.