Albatron Technology KI51PV-754 User Manual

 
 
 
 
 

 16 

 

USB devices attached to USB ports of the back panel can awaken the system from sleep mode.   

In order to enable this functionality, you must adjust the jumper caps on JP2 header for +5V or 
+5VSB mode depending on which USB port that the USB device is attached to.   

 
 

1

      Pin 1-2 Close 

+5V 

S1 sleep mode (CPU stopped, DRAM 
refreshed, system running in low power 
mode) 

1

      Pin 2-3 Close 

+5VSB  

S3/S4/S5 sleep modes (no power to 

CPU, DRAM in slow refresh, power 
supply in reduced power mode) 

 

Note: Close stands for putting a jumper cap onto two header pins. 

 
 
 

 

The “Clear CMOS” function is used when you are unable boot your system and need to reset 
the BIOS settings (CMOS settings) back to the manufacturer’s original settings. This is also a 

way to reset the system password if you have forgotten it. 

 

Normal (Default) 

Clear CMOS Data 

 

Note: Close stands for putting a jumper cap onto two header pins. 

 
 
 
 
 
 
 
 
 
 
 
 
 

1. Turn off your system and disconnect the AC power cable. 

 

2. Set JP1 header to OFF (2-3 Closed). 

 

3. Wait several seconds. 

 

4. Set JP1 header to ON (1-2 closed). 

 

5. Connect the AC power cable and turn on your system. 

 

6. Reset your new password. 

 
 
 
 
 
 
 
 
 
 
 
 

The following steps explain how to reset your CMOS 

configurations when you forgot a system password.