AMCC 9500S User Manual

Page of 103
Chapter 1. Introduction to the 3ware Command Line Interface
4
3ware Serial ATA RAID Controller CLI Guide 
Installing the 3ware CLI 
                                      
Installing the 3ware CLI on Windows
3ware CLI can be installed or run directly from the 3ware software CD, or the 
latest version can be downloaded from the 3ware web site,
 
. Online manual pages are also available in nroff and 
html formats. These are located in 
/packages/cli/tw_cli.8.html
 or 
tw_cli.8.nroff.
To install 3ware CLI on Windows
Copy the file 
tw_cli.exe
 to the directory from which you want to run the 
program. 
CLI is located on the 3ware CD in the directory 
\packages\cli\windows
                                      
Permissions Required to Run CLI
To run CLI, you can be logged onto Windows with one of the following sets 
of permissions:
Administrator
User with administrator rights
Domain administrator
Domain user with Domain Admin or Administrator membership
 Without the correct privileges, CLI will prompt and then exit when the 
application is executed. 
Warning!
If you are using 3DM, as opposed to 3DM2, AMCC does not recommend installing 
both 3DM and CLI on the same system. Conflicts may occur. For example, if both 
are installed, alarms will be captured only by 3DM. You should use either CLI or 
3DM to manage your 3ware RAID controllers.
This is not an issue for 3DM2. It can be installed with CLI.
(3DM was an earlier version of the software, which worked with 7/8000 model 
3ware controllers. 3DM 2 works with the 9000-series.)
Note:
 CLI comes in both 32-bit and 64-bit versions. Be sure to copy the correct 
version for the version of the operating system you are using.