AMCC 9500S User Manual

Unit Object Commands

69

                                      

The quiet attribute turns off interactive mode.

/c

x

/u

x

 set identify=on|off

This feature only applies to 9550SX, 9590SE, and 9650SE model controllers.

This feature requires an enclosure that uses an integrated AMCC/3ware CCU 
(chassis control unit). (Check the 3ware web site for a list of chassis vendors 
that support enclosure services, as they become available.)  For additional 
information about enclosure-related commands, see “Enclosure Object 
Commands” on page 87.

This command allows you to identify a unit within an enclosure by blinking 
the LEDs associated with the drive slots of the specified unit. 

 //localhost> /c0/u0 set identify=on

 Sending Identify request for unit /c0/u0 to [on] ... Done.

/c

x

/u

x

 set ignoreECC=on|off

This feature only applies to 9000 series controllers.

This command allows you to set the ignoreECC policy for a given unit.

When ignoreECC policy is set to off, if a rebuild process encounters bad 
sectors on the source disk, the rebuild will fail. When ignoreECC is set to on, 
such errors are ignored, and the rebuild will continue. When you use 
ignoreECC, a file system check is recommended following the rebuild, to 
insure data integrity.

By default, ignoreECC is off. 

7K/8K 

 Yes 

 Yes 

 Yes 

N/A

 Yes 

 N/A 

 N/A    

Yes 

No    

9000

a

a. Models 9500S, 9550SX, and 9590SE

 Yes 

 Yes 

 Yes 

N/A

 Yes 

 Yes 

 Yes    

Yes 

No    

9650SE

Yes

Yes

Yes

Yes

Yes

Yes

Yes

Yes

No