Black Box LPJ016A-TM User Manual

724-746-5500 | blackbox.com

Page 11

Chapter 3: Hardware Installation

3. Hardware Installation

3.1 Power Cord Requirements

Power cords must meet the requirements for the country where you will use the PoE Injector.

U.S. and Canada

• The cord must have a minimum of 10-A rated current competence.

• The cord must be UL

or CSA approved.

• The minimum requirement for the flexible cord is:

- 18 AWG (10-A)

- Three-conductor (line, neutral, ground)

- Type SV (stranded vacuum rubber jacketed) or SJ (stranded junior rubber jacketed) or SVT (stranded vacuum rubber

jacketed thermoplastic) or SJT (stranded junior thermoplastic)

• The plus must be earth-grounded with a NEMA 5-15 (15A, 125V) or NEMA 6-15P (15A, 250V) configuration.

Europe

Switzerland

• The supply plug must comply with SEV/ASE 1011.

Denmark

• The supply plug must comply with section 108-2-D1, standard DK2-1a or DK2-5a.

United Kingdom

• The PoE Gigabit Injector is covered by General Approval (section 16.16.060, NS/G/12345/J100003, for indirect connection to a

public telecommunication system.

France and Peru

• IT equipment cannot power this device. In the case of an IT-powered device, the unit needs to be powered by 230V through an

isolation transformer with a ratio of 1:1 and the secondary connection (neutral) is properly grounded.

• The PoE Gigabit Injector must have access to a nearby power outlet. By disconnecting the power cord from the outlet, you will

eliminate power from the device.

• The flexible cord that connects to the PoE Gigabit Injector must have a configuration to connect with an EN60320/IEC320 inlet

connector.

• According to the EN60950/IEC 950 specifications, this device functions under SELV (Safety Extra Low Voltage) conditions. The

conditions are true if the equipment and the connected device functions under SELV conditions.