Black Box LPJ016A-TM User Manual
724-746-5500 | blackbox.com
Page 14
724-746-5500 | blackbox.com
802.3af and 802.3at PoE Gigabit Injectors
3.5.2 Click System Reset on the Graphical User Interface (GUI)
1. AC LED remains green
2. Ethernet LED remains off until the unit is connected
3. 24 ports (with ports connected): same sequence as Cold Start
4. 24 ports (without ports connected): same sequence as Cold Start
2. Ethernet LED remains off until the unit is connected
3. 24 ports (with ports connected): same sequence as Cold Start
4. 24 ports (without ports connected): same sequence as Cold Start
Table 3-1 LED Indicators.
Indicator
Conditions
LED Off
Green
Orange
Blinking Orange
Port LED
Indicates port is
Indicates port is
Indicates port has
Indicates port is
disabled
connected
an error
disconnected but enabled
Ethernet LED Indicates Ethernet is
N/A
Indicates NIC is
N/A
disconnected from
connected to
network
network
AC LED
Indicates PoE Gigabit
Indicates PoE Gigabit
N/A
N/A
Injector is not powered Injector is powered
3.6 Rackmounting Installation
Position the PoE Gigabit Injector on the rack. Line up the mounting bracket with the corresponding screw holes on the PoE
Gigabit Injector. (See Figure 3-6.) Keep the screw area visible to insert screws, and then tighten the screws. (See Figure 3-7.)
Screws and brackets are included in the package.
Gigabit Injector. (See Figure 3-6.) Keep the screw area visible to insert screws, and then tighten the screws. (See Figure 3-7.)
Screws and brackets are included in the package.
Figure 3-6. 24-port PoE Gigabit Injector with rackmount brackets attached.
Bracket
Screws
PoE Gigabit
Injector
Figure 3-7. Close-up view of rackmounting bracket and screws (side/rear).