GE LTC-MAP 2130 User Manual

1.  Before applying power to the system, verify that: 

• 

All sensors are mounted and connected properly. 

• 

None of the wiring or cables are shorted. 

• 

All connections follow the wiring and installation diagrams. 

• 

All monitored input signals are within specified input ranges. 

• 

Phone lines are properly connected to a phone multiplexer (if used). 

 

WARNING: Check all wiring before applying power to the unit.  Wiring 

errors can damage the device and create a safety hazard. 

2.  Connect the power input wires to the 120 V AC/DC Power terminal. 

3.  Apply power to the monitor.  

NOTE: Copyright information will be displayed for approximately 

ten seconds.  After that, the display will go blank. 

        L  T  C  -  M  A  P    2  1  3  0         

    r  e  v    2  1  3  0  .  x  x  .  y  y         

                                       

  c  o  p  y  r  I  g  h  t    (  C  )    1  9  9  7   

4.  Configure and set system parameters using the SAGE



 host software 

package. (Refer to the SAGE



 documentation for specific 

procedures.) 

5.  Upload the SAGE



 configuration files to the LTC-MAP, either through 

the RS232 Serial port or via a modem. (Refer to the SAGE



 

documentation for specific procedures.) 

6.  Verify the current date and time. 

• 

Press the 

 button two times or until the 

Current Time and Current Date screen is displayed: 

 

      C  u  r  r  e  n  t    T  i  m  e  :         

          1  2  :  3  0  :  2  2               

      C  u  r  r  e  n  t    D  a  t  e  :         

    W  e  d        0  9  /  1  7  /  1  9  9  7     

 

• 

If the time and date are incorrect, reset them using the procedures 
outlined in the SAGE



 documentation. 

NOTE: The date and time must be set accurately to insure that LTC-

MAP 2130 properly acquires data.