Nortel Networks 311 User Manual
Controls and indicators
421
Controls and indicators
The LEDs on the DAC faceplate indicate the status mode for each port.
shows the
NT7D16 DAC faceplate.
Card status
The LED at the top of the faceplate is unlabeled. This LED is:
•
off: if one or more ports are enabled
•
on: if all ports are disabled
Electronic Industries Association signal monitors
The six LEDs located below the card status LED are labeled SD, RD,
DTR, DSR, DCD, and RI. They show the dynamic state of the associated
Electronic Industries Association (EIA) control leads for a specific port (as
shown by the display). When in RS-422 mode, only SD and RD are utilized.
When in RS-232-C mode, the LED goes on to indicate that the signal is
asserted on, or off to indicate that the signal is asserted off. When the LED
is off, there is no active voltage on the signal lead.
DTR, DSR, DCD, and RI. They show the dynamic state of the associated
Electronic Industries Association (EIA) control leads for a specific port (as
shown by the display). When in RS-422 mode, only SD and RD are utilized.
When in RS-232-C mode, the LED goes on to indicate that the signal is
asserted on, or off to indicate that the signal is asserted off. When the LED
is off, there is no active voltage on the signal lead.
CONNECT
This lamp lights to indicate that a data call is established for the port
displayed. A data call is connected when the data module-to-data module
protocol messages are successfully exchanged between the two ends.
displayed. A data call is connected when the data module-to-data module
protocol messages are successfully exchanged between the two ends.
Port mode
This lamp lights to indicate that the port indicated is in RS-422 mode. If the
lamp is dark, the specified port is in RS-232-C mode.
lamp is dark, the specified port is in RS-232-C mode.
Port number
The number displayed specifies the port driving the EIA signal LEDs
mentioned above. The push-button switch below the display allows you to
rotate among the six ports to monitor the activity of any port. This display
is also used to monitor several error conditions.
mentioned above. The push-button switch below the display allows you to
rotate among the six ports to monitor the activity of any port. This display
is also used to monitor several error conditions.
Port select button
This push-button switch below the display is used to select which port
is monitored.
is monitored.
Wire test
These switches are used to select the wire test mode for each of the six
ports.
ports.
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311
01.04
Standard
Release 5.0
23 May 2008
Copyright © 2003-2008, Nortel Networks
.