Nortel Networks 311 User Manual
Operation
47
Figure 10
IPE trunk cards installed in an NT8D37 IPE module
IPE trunk cards installed in an NT8D37 IPE module
3
Install the cable that connects the backplane connector on the IPE
module to the module I/O panel.
module to the module I/O panel.
4
Connect a 25-pair cable from the module I/O panel connector to the
Main Distribution Frame (MDF).
Main Distribution Frame (MDF).
5
Connect the trunk card output to the selected terminal equipment
at the MDF.
at the MDF.
6
Configure the individual trunk interface unit using the Trunk
Administration program (LD 14) and the Trunk Route Administration
program (LD 16).
Administration program (LD 14) and the Trunk Route Administration
program (LD 16).
—End—
Once these steps are complete, the trunk card is ready for use.
Operation
This section describes how trunk cards fit into the CS 1000E, CS 1000M,
and Meridian 1 architecture, the buses that carry signals to and from the
trunk cards, and how they connect to terminal equipment. See
and Meridian 1 architecture, the buses that carry signals to and from the
trunk cards, and how they connect to terminal equipment. See
for IPE parameters.
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311
01.04
Standard
Release 5.0
23 May 2008
Copyright © 2003-2008, Nortel Networks
.