Nortel Networks 311 User Manual
Operation
755
•
If the far-end is equipped for sending, the system can operate in any
mode (immediate start, delay dial, or wink start), as assigned on a start
arrangement basis. See
mode (immediate start, delay dial, or wink start), as assigned on a start
arrangement basis. See
.
— In immediate start mode, there is no start signal from the called
office. The seizure signal (off hook supervisory state) from the
far-end should be at least 150 ms. At the end of the seizure signal,
the far-end can start pulsing after the standard delay (normally 70
ms minimum).
far-end should be at least 150 ms. At the end of the seizure signal,
the far-end can start pulsing after the standard delay (normally 70
ms minimum).
— In delay dial mode, a 256-384 ms off hook/on hook signal is returned
to the far-end immediately after receipt of the seizure signal. When
the far-end detects the on hook signal (start signal), the far-end can
start pulsing after the standard delay (normally 70 ms minimum).
the far-end detects the on hook signal (start signal), the far-end can
start pulsing after the standard delay (normally 70 ms minimum).
— In wink start mode, within a 128–256 ms period after receipt of the
seizure signal from the far-end, the called office transmits a 250 ms,
wink start, off hook/on hook signal to the calling office.
wink start, off hook/on hook signal to the calling office.
Table 270
Operation Mode
Operation Mode
Operation mode
Start arrangement
Immediate start
IMM
Delay dial
DDL
Wink start
WNK
The far-end initiates calls as follows:
•
Ground is placed on the E lead in E and M signaling.
•
Dial pulses are subsequently applied from the far-end as ground open
on the E lead.
on the E lead.
•
If the far-end is equipped for sending, the system may be operated in
any mode (immediate start, delay dial, or wink start), as assigned on a
start arrangement basis. See
any mode (immediate start, delay dial, or wink start), as assigned on a
start arrangement basis. See
.
— In immediate start mode, there is no start signal from the called
office. The seizure signal (off hook supervisory state) from the
far-end should be at least 150 ms. At the end of the seizure signal,
the far-end may start pulsing after the standard delay (normally 70
ms minimum).
far-end should be at least 150 ms. At the end of the seizure signal,
the far-end may start pulsing after the standard delay (normally 70
ms minimum).
— In delay dial mode, a 256–384 ms off hook/on hook signal is returned
to the far-end immediately after receipt of the seizure signal. When
the far-end detects the on hook state of the signal (the start signal),
the far-end may start pulsing after the standard delay (normally 70
ms minimum).
the far-end detects the on hook state of the signal (the start signal),
the far-end may start pulsing after the standard delay (normally 70
ms minimum).
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311
01.04
Standard
Release 5.0
23 May 2008
Copyright © 2003-2008, Nortel Networks
.