Omega OMB-DAQBOARD-3000 User Manual

7.  Refer to the figure at the right.  Align the groove in the 

DaqBoard’s PCI edge-connector with the ridge of the 
desired PCI slot, and with the PC’s corresponding rear-
panel slot. 

8.  Push the board firmly into the PCI slot.  The board will 

snap into position. 

9.  Secure the board by inserting the rear-panel adapter-plate 

screw. 

10.  Using the previous steps, install additional boards into 

available PCI bus-slots, if applicable to your application. 

11.  Replace the computer’s cover. 

12.  Plug in all cords and cables that were removed in step 1. 

13.  Apply power to, and start up the PC. 

Note:  At this point some PCs may prompt you to insert an 

installation disk.  While this is rare, if you do receive such a 
prompt simply place the install CD-ROM into the disk drive 
and follow additional screen prompts. 

 

 

DaqBoard/2000 and /3000 Series Boards have no jumpers or switches to set.  Configuration is 
performed, in its entirety, through software.  Refer to the following figure and steps to complete the 
configuration.   

The numbers in the figures correspond to the numbered steps which immediately follow. 

 

 

         Images are similar for DaqBoard/3000 Series boards. 

1033-0940, rev 8.0 

918494

 

DaqBoard Installation Guide   IG-5