Motorola 68HC912D60 User Manual
18
ANALOG PORT
PAD0
1 2
PAD8
PAD1
3 4
PAD9
PAD2
5 6
PAD10
PAD3
7 8
PAD11
PAD4
9 10 PAD12
PAD5 11 12 PAD13
PAD6 13 14 PAD14
PAD7 15 16 PAD15
PAD6 13 14 PAD14
PAD7 15 16 PAD15
VRL0 17 18 VRH0
VRL1 19 20 VRH1
VRL1 19 20 VRH1
The ANALOG port provides access to the Port AD0 and
Port AD1 Analog-to-Digital input lines.
Port AD1 Analog-to-Digital input lines.
PAD0 – PAD7 HC12 Port AD0-15 is an input port or A/D
Converter inputs.
Converter inputs.
VRH / VRL HC12 A/D Converter Reference Pins. See
A/D Reference Section. To provide an external reference
voltage, R3,4,10 and 32 may need to be removed. See
schematic.
A/D Reference Section. To provide an external reference
voltage, R3,4,10 and 32 may need to be removed. See
schematic.
COM1
1
TXD0 2 6
RXD0 3 7
4
8
GND 5 9
The COM-1 port has a Female DB9 connector that interfaces to
the HC12 internal SCI0 serial port. It uses a simple 2 wire
asynchronous serial interface and is translated to RS232
signaling levels.
the HC12 internal SCI0 serial port. It uses a simple 2 wire
asynchronous serial interface and is translated to RS232
signaling levels.
COM2
1
2
TXD1 3
4
RXD1 5
6
7
8
GND 9 10
The COM-2 has a Female DB9 connector that interfaces to the
HC12 internal SCI1 serial port. It uses a simple 2 wire
asynchronous serial interface and is translated to RS232
signaling levels.
JP1 may be used to reverse RS232 RX and TX signals to the
COM2 connector.
HC12 internal SCI1 serial port. It uses a simple 2 wire
asynchronous serial interface and is translated to RS232
signaling levels.
JP1 may be used to reverse RS232 RX and TX signals to the
COM2 connector.
NOTE:
1) COM1 and 2 connector Pins 1, 4, and 6 are connected for default handshake standards.
2) COM1 and 2 connector Pins 7 and 8 are connected for default handshake standards.
3) Handshake pins are provided access pads behind the COM connectors for user
application and can be easily isolated from each other on the bottom of the CMD912x
board.
board.
4) SCI0:PS0/RXD0 and SCI1:PS2/RXD1 signals can be isolated from the RS232 transceiver
by turning COM Switch positions 1 and 2 OFF respectfully.
5) SCI0:PS1/TXD0 and SCI1:PS3/TXD1 signals can be isolated from the RS232 transceiver
by removing resistors R10 and R11 respectfully from the bottom of the CMD912x board.