Fluke A70M User Manual
2. INSTALLATION
Page 11
© 2007 DH Instruments, a Fluke Company
2.4.3.2
RPM4 REAR PANEL
1. 12VDC Power Supply Connection
2. Accessories connector (to HPMS rear
2. Accessories connector (to HPMS rear
panel FOOTSWITCH and LEDs)
3. IEEE-488
Connector
4. COM2
Connector
5. COM1
Connector
6. Power
Switch
7. Fuse
8.
Electrical Power Connector
(IEC-320-C13)
9. Fan
9. Fan
10. TEST(+) Pressure Port, Lo Q-RPT
11. TEST(+) Pressure Port, Hi Q-RPT
12. ATM Pressure Port, Lo Q-RPT
13. ATM Pressure Port, Hi Q-RPT
14. Product Label (bottom of case)
11. TEST(+) Pressure Port, Hi Q-RPT
12. ATM Pressure Port, Lo Q-RPT
13. ATM Pressure Port, Hi Q-RPT
14. Product Label (bottom of case)
Figure 6. RPM4 rear panel
2.4.4
POWER CONNECTION
Connect the supplied power cable to the RPM4 rear panel power module.
Connect the other end of the power cable to an electrical supply of 85 to 264 VAC,
50/60 Hz.
2.4.5
FOOTSWITCH CONNECTION
Connect the foot switch supplied in the RPM4/HPMS accessories to the HPMS rear panel
electrical connection labeled FOOT SWITCH. Place the foot switch on the floor at a convenient
location (see Section 2.2, Figure 1). The FOOT SWITCH function is equivalent to the RPM4 front
panel [ENT] key and may be used frequently while running tests and calibrations.
electrical connection labeled FOOT SWITCH. Place the foot switch on the floor at a convenient
location (see Section 2.2, Figure 1). The FOOT SWITCH function is equivalent to the RPM4 front
panel [ENT] key and may be used frequently while running tests and calibrations.
2.4.6
TEST PORT CONNECTION
A single high pressure TEST port is provided on the rear panel of the HPMS.
The test port connection is a DH500 F. DH500 is a gland and collar type fitting for 1/4 in.
(6 mm) coned and left hand threaded tube. DH500 is equivalent to AE F250C, HIP HF4, etc.
(6 mm) coned and left hand threaded tube. DH500 is equivalent to AE F250C, HIP HF4, etc.
Connection to GPC1 if the RPM4/HPMS is Part of an PGC-10000-AF System
If the RPM4/HPMS was delivered as part of a PGC-10000-AF Pneumatic Gauge Calibrator, a
GPC1 Gas Pressure Controller was delivered with it. The GPC1 includes a fittings kit with
the necessary fittings to interconnect the RPM4/HPMS and GPC1 as well as instructions on
making the connection. See the GPC1-10000-AF manual.
GPC1 Gas Pressure Controller was delivered with it. The GPC1 includes a fittings kit with
the necessary fittings to interconnect the RPM4/HPMS and GPC1 as well as instructions on
making the connection. See the GPC1-10000-AF manual.