Motorola MVME187 User Manual
3-14
Hardware Preparation and Installation
3
Preparing the MVME187 for Installation
Refer to the setup procedures in the manuals for your particular
chassis or system for additional details concerning the installation
of the MVME187 into a VME chassis.
chassis or system for additional details concerning the installation
of the MVME187 into a VME chassis.
Table 3-7. MVME187 Preparation Procedure
Step
Action
1
Install/remove jumpers on headers according
to the
chapter and as required for your particular application.
❏
. The default condition is with all eight jumpers installed
❏
A jumper installed/removed on header J2 enables/disables the
system controller function of the MVME187.
system controller function of the MVME187.
❏
Install jumpers on headers J7 and J8 to configure serial port 4 to
use clock signals provided by the TRXC4 and RTXC4 signal lines.
use clock signals provided by the TRXC4 and RTXC4 signal lines.
2
ConÞgure adapters and transition modules
according to the MVME712X
transition module
user's manuals.
3
Ensure that EPROM devices are properly installed in their sockets.
❏
Factory configuration is with two EPROMs installed for the
MVME187Bug debug monitor, in sockets XU1 and XU2.
MVME187Bug debug monitor, in sockets XU1 and XU2.