Soyo SY-K7VEMPRO User Manual
BIOS Setup Utility
SY-K7VEMPRO
66
3-4.4 FDC Controls
FDC Controls
Setting
Description
Note
Disabled
Turn off the on-board
floppy controller
floppy controller
Onboard FDD
controller
controller
Enabled
Use the on-board floppy
controller
controller
Default
3-4.5 Onboard Serial Ports
Onboard Serial
Ports
Ports
Setting
Description
Note
Disabled
3F8/IRQ4
Default
(port 1)
(port 1)
2F8/IRQ3
Default
(port 2)
(port 2)
3E8/IRQ4
2E8/IRQ3
Onboard
Serial Port 1 /
Serial Port 2
Serial Port 1 /
Serial Port 2
Auto
Choose serial port 1 & 2's I/O
address.
Do not set port 1 & 2 to the
same address except for
Disabled or Auto.
address.
Do not set port 1 & 2 to the
same address except for
Disabled or Auto.
Standard
Default
HPSIR
UART 2 Mode
ASKIR
The second serial port offers
these InfraRed interface
modes.
these InfraRed interface
modes.
If [UART 2 Mode] is set to [HPSIR]/[ASKIR]
Half
Default
IR Function
Duplex
Duplex
Full
Choose [Half] or [Duplex] to
set UR2 in half duplex mode
or full duplex mode
respectively. Refer to your IR
device specifications to select
the suitable mode.
set UR2 in half duplex mode
or full duplex mode
respectively. Refer to your IR
device specifications to select
the suitable mode.
No,Yes
Default
TX,RX inverting
enable
enable
No, No/
Yes, No/
Yes, Yes.
Yes, No/
Yes, Yes.
This item allow you to enable
the TX, RX inverting which
depends on different H/W
requirement. This field is not
recommended to change its
default setting for avoiding
any error in your system
the TX, RX inverting which
depends on different H/W
requirement. This field is not
recommended to change its
default setting for avoiding
any error in your system