Casio G486VPB User Manual
PCI/ISA System Board
52
Step 2
Install the other 34-pin header connector(s) into the disk
drive(s) with the colored edge of the daisy chained
ribbon cable aligned to pin 1 of the drive edge
connector(s). The end-most connector should be at-
tached to the drive you want to be Drive A.
Install the other 34-pin header connector(s) into the disk
drive(s) with the colored edge of the daisy chained
ribbon cable aligned to pin 1 of the drive edge
connector(s). The end-most connector should be at-
tached to the drive you want to be Drive A.
IDE Hard Disk Interface
The G486VPB system board is equipped with one VL-
Bus IDE connector and one ISA IDE connector that will
interface four IDE (Integrated Drive Electronics) hard
disk drives. An IDE drive is a hard drive with the con-
troller electronics built into the disk assembly. The
integration of the controller and the drive as a single
unit increases both the reliability and performance by
eliminating redundant circuitry.
Bus IDE connector and one ISA IDE connector that will
interface four IDE (Integrated Drive Electronics) hard
disk drives. An IDE drive is a hard drive with the con-
troller electronics built into the disk assembly. The
integration of the controller and the drive as a single
unit increases both the reliability and performance by
eliminating redundant circuitry.
Note:
Only IDE drives can be connected to the IDE interface.
Only IDE drives can be connected to the IDE interface.