Black Box VSPX-HDMI-RX User Manual
724-746-5500 | blackbox.com
Page 23
Chapter 4: Installation
4. Installation
To broadcast HDMI signals to four remote displays with a local port, follow
these instructions.
1. Turn off all devices, including sources and displays.
2. Connect an HDMI source (such as a Blu-ray disc player) to the HDMI port on
these instructions.
1. Turn off all devices, including sources and displays.
2. Connect an HDMI source (such as a Blu-ray disc player) to the HDMI port on
the transmitter.
3. Connect the receivers via CAT5/5e/6 cables to each HDMI signal output port.
4. Connect the local HDMI equipped monitor.
5. Set EDID DIP switch settings of the transmitter according to your displays
4. Connect the local HDMI equipped monitor.
5. Set EDID DIP switch settings of the transmitter according to your displays
(Chapter 3).
6. If the monitor’s resolution or refresh rate differs from the extender’s built in
EDID settings, set DIP switch to EDID learning to copy the EDID from the local
monitor (Section 3.2).
monitor (Section 3.2).
7. Plug in the 5-VDC, 4-A power supplies.
8. Power on the HDMI displays.
9. Power on the HDMI source device.
10. If you see a flickering or blinking image on the remote displays, adjust the
8. Power on the HDMI displays.
9. Power on the HDMI source device.
10. If you see a flickering or blinking image on the remote displays, adjust the
rotary control switch on the receivers to adjust the video signal strength
(see Table 2-2 or 2-3).
(see Table 2-2 or 2-3).
11. If you are installing several VSPX-HDMI-CSRX units in a cascade setup,
always start by adjusting signal strength on the unit nearest the transmitter,
and move on to the adjacent units.
and move on to the adjacent units.
Diagram Format
Rule Size: 0.013
VSPX-HDMI1X4-TX
VSPX-HDMI-RX
HDMI source
Local HDMI
monitor
HDMI output
monitor
Figure 4-1. Connection diagram.