Soyo 400 User Manual
Hardware Installation
SY-KT880 DRAGON 2 V2.0
42
3.3V
-12V
GND
PS-ON
GND
GND
GND
-5V
5V
5V
3.3V
3.3V
GND
5V
GND
5V
GND
PW-OK
5VSB
12V
ATX Power
Note 3: The minimum recommended wattage is 400W for a
fully loaded system or 350W for a minimally loaded system,
the system might become unstable if power supply is not
enough
fully loaded system or 350W for a minimally loaded system,
the system might become unstable if power supply is not
enough
Note 4: The 4 pin ATX 12V must be connected to the motherboard.
Without this connector, the system cannot boot.
Without this connector, the system cannot boot.
The KT880 DRAGON 2 requires a power supply that is approved by AMD,
of at least 350W. Go to
of at least 350W. Go to
http://www.amd.com
for more info on approved
power supply. Make sure the ATX power supply can take at least 720 mA *
load on the 5V Standby lead (5VSB) to meet the standard ATX
specification.
* Note: If you use the Wake-On-LAN (WOL`) function, make sure the ATX
power supply can support at least 720 mA on the 5V Standby lead (5VSB).
Please install the ATX power according to the following pin assignment:
load on the 5V Standby lead (5VSB) to meet the standard ATX
specification.
* Note: If you use the Wake-On-LAN (WOL`) function, make sure the ATX
power supply can support at least 720 mA on the 5V Standby lead (5VSB).
Please install the ATX power according to the following pin assignment:
Pay special care to the directionality.
+12V Power Connector
Pin1 Pin3
+12VDC
COM
FIG. 1
FIG. 2