Sony AR-B1570 User Manual
AR-B1570 User’s Guide
4
0.6 ORGANIZATION
This manual covers the following topics (see the Table of Contents for a detailed listing):
!
Chapter 1, “Overview”, provides an overview of the system features and packing list.
!
Chapter 2, “System Controller” describes the major structure.
!
Chapter 3, “Setting Up the System”, describes how to adjust the jumper, and the connector’s settings.
!
Chapter 4, “Installation”, describes setup procedures including information on the utility diskette.
!
Chapter 5, “BIOS Console”, provides the BIOS options settings.
0.7 STATIC ELECTRICITY PRECAUTIONS
Before removing the board from its anti-static bag, read this section about static electricity precautions.
Static electricity is a constant danger to computer systems. The charge that can build up in your body may be
more than sufficient to damage integrated circuits on any PC board. It is, therefore, important to observe basic
precautions whenever you use or handle computer components. Although areas with humid climates are much
less prone to static build-up, it is always best to safeguard against accidents that may result in expensive repairs.
The following measures should be sufficient to protect your equipment from static discharge:
Static electricity is a constant danger to computer systems. The charge that can build up in your body may be
more than sufficient to damage integrated circuits on any PC board. It is, therefore, important to observe basic
precautions whenever you use or handle computer components. Although areas with humid climates are much
less prone to static build-up, it is always best to safeguard against accidents that may result in expensive repairs.
The following measures should be sufficient to protect your equipment from static discharge:
•
Touch a grounded metal object to discharge the static electricity in your body (or ideally, wear a grounded
wrist strap).
wrist strap).
•
When unpacking and handling the board or other system components, place all materials on an anti-static
surface.
surface.
•
Be careful not to touch the components on the board, especially the “golden finger” connectors on the bottom
of the board.
of the board.