Soyo SY-5S User Manual

Please install the ATX power according to the following pin

assignment:

Ø Pay special care to the directionality.

Ø Make sure pin 1 is in its position.

After you have turned off your computer, clear the CMOS memory

by momentarily shorting pins 2-3 on jumper JP5, for a few seconds.

Then restore JP5 to the initial 1-2 jumper setting in order to recover

and retain the default settings.

You have now completed the hardware installation of your

mainboard successfully.

1. Turn the power on

2. To enter the BIOS Setup Utility, press the <DEL> key while the

system is performing the diagnostic checks,

Note: If you have failed to enter the BIOS, wait until the boot

up sequence is completed. Then push the RESET button and

press <DEL> key again at the beginning of boot-up, during

diagnostic checks.

Repeat this operation until you get the following screen.

ATX Power

12V

5VSB

PW-0K

GND

5V

GND

5V

GND

3.3V

3.3V

5V

5V

-5V

GND

GND

GND

PS-ON

GND

-12V

3.3V