Soyo P55C User Manual

Page of 43
34
BIOS Setup
Parallel Port Mode
Choose ECP + EPP (default), Normal
or EPPECP mode. The mode depends
on your external device that connects to
this port.
ECP Mode Use DMA
Choose DMA3 (default) or DMA1.
This setting only works when the
Onboard Printer Mode is set at the ECP
mode.
Parallel Port EPP Type
Choose EPP specification Ver. 1.7 or 1.9
(default).
Supervisor Password
Based on the setting you made in the ÒSecurity OptionÓ of the ÒBIOS
FEATURES SETUPÓ, this Main Menu item lets you configure the
system so that a password is required every time the system boots or an
attempt is made to enter the Setup program.  Change the password as
follows:
1.
Choose ÒSUPERVISOR PASSWORDÓ in the Main Menu and press
<Enter>. The following message appears:
ÒEnter Password:Ó
2.
Enter a password and press <Enter>.
(If you do not wish to use the password function, you can just press
<Enter> and a ÒPassword disabledÓ message appears. )
3.
After you enter your password, the following message appears
prompting you to confirm the new password:
ÒConfirm Password:Ó
4.
Re-enter your password and then Press <ESC> to exit to the Main
Menu.
Important: If you forget or lose the password, the only way to access
the system is to set jumper JP5 to clear the CMOS RAM.
All setup information is lost and you must run the BIOS
setup program again.