Soyo SY-7ISA+ Motherboard User Manual

The SY-7ISA+ provides over-clocking capability. Due to the over-

clocking setting your system may fail to boot up or hang during run time.

Please perform the following steps to recover your system from the

abnormal situation :

1. Turn off system power (If you use an ATX power supply, and

depending on your system, you may have to press the power button

for more than 4 seconds to shut down the system.)

2. Press and hold down the <Insert> key while turning on the system

power. Keep holding down the <Insert> key until you see the

message of the CPU type and frequency shown on the screen.

3. Press the <Del> key during the system diagnostic checks to enter the

Award BIOS Setup program.

4. Select [Save & Exit SETUP] and press <Enter> to save the new

configuration to the CMOS memory, and continue the boot

sequence.

There are two possible ways to turn off the system:

1. Use the Shutdown command in the Start Menu of Windows 95/98

to turn off your computer.

2. Press the mechanical power-button and hold down for over 4

seconds, to shutdown the computer. If you press the power-button for

less than 4 seconds, then your system will enter into Suspend Mode.

You are now ready to configure your system with the BIOS setup program.

Go to Chapter 3: BIOS SETUP