Tascam IF-FW User Manual

Illegal FS

The Mixer specified an unsupported

sampling frequency. Since the IF-FW/DM

II supports

all of the sampling frequencies that the DM-3200 and DM-
4800 supports, this might indicate a hardware problem.
No Cable

There is no physical connection

being detected between the IF-FW/DM

II and the

computer, the cable is likely to be unplugged at one end.
Driver Offline The

IF-FW/DM

II is connected

physically to the computer, but no compatible driver is
available.
Driver Not Locked The

IF-FW/DM

II is connected to

the computer, but the driver is not providing data at the
correct rate for stable audio, or the mixer’s Sampling Rate
is outside the usable range. If the FS is correct and this
condition persists, restart your computer.
FS Mismatch

The IF-FW/DM

II is connected to

the computer, but the driver is not providing data at the
same sampling frequency as the mixer. Your DAW project
is probably set to use a different FS than the mixer is
currently set to.
Not Ready

The

IF-FW/DM

II hardware is

not ready to start FireWire Audio transfer.

Input

This allows restricting the number of channels coming from the
computer to 16 for reduced host load, or setting the full channel
count of 32. Especially at high sampling rates, if you don’t
need the full 32 channel count from the computer to the mixer
for a project, you will get better performance from your
computer by setting this to 16.
(Note) Before changing this setting, be sure that no audio
applications are running, and no sound is being played back
through the IF-FW/DM

II. After changing the setting, wait a

few seconds for the driver and OS to reconfigure to the new
setting before re-launching your audio application.