Intel D925XBC User Manual

Page of 112
Product Description 
 
For information about  
Refer to 
The location of the Serial ATA IDE connectors on the D925XCV board 
Figure 21, page 68 
The location of the Serial ATA IDE connectors on the D925XBC board 
Figure 22, page 70 
1.7.2.3  Serial ATA RAID 
The ICH6-R supports RAID (Redundant Array of Independent Drives) level 0 and RAID level 1 on 
the Serial ATA ports as follows: 
•  RAID 0 supports data striping.  Two physical drives, of identical size, can be teamed together 
to create one logical drive.  As data is written or retrieved from the logical drive, both drives 
operate in parallel, thus increasing the throughput. 
•  RAID 1 supports data mirroring.  Two physical drives, of identical size, maintain duplicate sets 
of all data on separate disk drives.  Level 1 provides the highest data reliability because two 
complete copies of all information are maintained. 
1.7.2.4  RAID Boot Configuration Overview 
A RAID array can be created by using the existing Serial ATA ports, correctly configuring the 
BIOS, and installing drivers.  The following steps are required to successfully establish a RAID 
configuration. 
1.  Enable RAID Support in BIOS.  
2.  Create a RAID array using the Intel Application Accelerator (IAA) utility. 
3.  Install the IAA RAID driver.  
4.  Format the RAID array. 
5.  Install the IAA Companion Utility (this step is optional). 
 
For information about  
Refer to 
Serial ATA RAID configuration 
http://developer.intel.com/design/motherbd/cv/index.htm 
1.7.2.5  SCSI Hard Drive Activity LED Connector (Optional) 
The SCSI hard drive activity LED connector is a 1 x 2-pin connector that allows an add-in 
hard drive controller to use the same LED as the onboard IDE controller.  For proper operation, this 
connector should be wired to the LED output of the add-in hard drive controller.  The LED 
indicates when data is being read from, or written to, either the add-in hard drive controller or the 
onboard IDE controller (Parallel ATA or Serial ATA). 
 
NOTE 
The SCSI Hard Drive Activity LED connector is an option available only on the D925XCV board.  
It is not available on the D925XBC board. 
 
For information about  
Refer to 
The location of the SCSI hard drive activity LED connector on the  
D925XCV board 
Figure 21, page 68 
The signal names of the SCSI hard drive activity LED connector  
Table 26, page 73 
 27