Line 6 TonePort DI User Manual

Connect a microphone 

Connect your electric guitar or bass

Connect your stereo headphones

Mic - To input a signal from a microphone, connect it here using an XLR cable. When in POD Farm 

Standalone operation, this inputs the microphone signal into POD Farm, where you can choose your 

Tone, and then route the processed signal both to the Record Sends (to your audio software) and 

directly to the UX1 hardware outputs.

Instrument Input - To input your electric guitar or bass, plug it in here using a standard 1/4-inch TS 

instrument cable. When in POD Farm Standalone operation, this inputs the signal into POD Farm 

where you can choose your tone, and then route the processed signal both to the Record Sends (to your 

audio software) and directly to the UX1 hardware outputs.

Phones - If you want to listen to the audio from UX1 using stereo headphones, then plug them into this 

1/4-inch stereo jack. This headphone jack outputs the same signal fed to the Analog Outs on the rear 

panel; the audio from your audio software, as well as anything plugged into any front panel input.

Connect any line level input 

source that you want to record 

into the Line Inputs

Connect any line level input 

source for monitoring to the Stereo 

Monitor In

Connect a USB cable from here to 

your computer’s USB port

Connect the Analog Outs 

to your audio monitors

Line Inputs - To record the signal from a line level source, such as a keyboard, your stereo receiver, 

the line out from a mixing console, etc., connect to these Left and Right ins using 1/4-inch TS audio 

cables.