Promise Technology M310p User Manual
Chapter 2: Installation
15
Connect the Power
Plug the power cords and switch on both power supplies on. When the power is
switched on, the LEDs on the front of the VTrak will light up.
switched on, the LEDs on the front of the VTrak will light up.
Figure 10.VTrak M310p/M210p front panel LED display
When boot-up is finished and the VTrak is functioning normally:
•
Controller Heartbeat LED blinks green seven times in three seconds, goes
dark for six seconds, then repeats the blink pattern.
dark for six seconds, then repeats the blink pattern.
•
Power, FRU and Logical Drive LEDs display green continuously.
•
The RAID Controller LED flashes green if there is activity on the controller.
There are two LEDs on each Drive Carrier. They report the presence of power
and a disk drive, and the current condition of the drive.
and a disk drive, and the current condition of the drive.
Figure 11. VTrak M310p/M210p disk carrier LEDs
After a few moments the Power/Activity should display Green.
Power
Reserved
FRU Status
Logical Drive Status
RAID Controller Activity
Controller Heartbeat
Disk Status
Power/Activity