Lucent Technologies R5SI User Manual

Issue 1

April 1997

Maintenance Object Repair Procedures 

Page 10-541

DS1-BD (DS1 Interface Circuit Pack) 

0

NO BOARD

The test could not relate the internal ID to the port (no board). 

This could be due to incorrect translations, no board is inserted, an incorrect 
board is inserted, or an insane board is inserted.

1. Check to ensure that the board translations are correct. Use the 

 command to administer the DS1 interface if it is not already 

administered.

2. If board was already administered correctly, check the error log to 

determine if the board is hyperactive. If this is the case, the board is shut 
down. Reseating the board will re-initialize the board.

3. If the board was found to be correctly inserted in step 1, issue the 

 command.

4. Issue the 

 command.

5. Issue the 

 command.

6. Issue the 

 command.

This should re-establish the linkage between the internal ID and the port.

None

ABORT

System resources required for this test are not available. 

1. Retry the command at 1-minute intervals a maximum of 5 times.

1005

ABORT

Wrong circuit pack configuration to run this test. This error applies only to 
DS1 Interface circuit packs. It means the DS1 Interface circuit pack is 
providing timing for the system and, therefore, it cannot be reset without 
major system disruptions.

1. If the circuit pack needs to be reset, then set synchronization to another 

DS1 Interface circuit pack or to the Tone-Clock circuit pack and try 
again. Refer to "SYNC (Synchronization)".