Lucent Technologies R5SI User Manual

Issue 1

April 1997

Maintenance Commands and Trouble-Clearing Aids 

Page 8-291

release packet-control 

The release packet-control command will put the packet-control circuit pack 
in-service, and reestablish each point-to-point signaling link that is terminated on 
this packet-control. This command is the complement to the busyout 
packet-control command which puts the packet-control in a out-of-service state 
and tears down all point-to-point signaling links terminated on this 
packet-control.

For simplex systems, the location is optional and defaults to cabinet 1, carrier A. 
For duplex systems, the cabinet default is again cabinet 1, but there is no default 
for the carrier.

If the system technician presses 

HELP

 after entering "release packet-control," the 

following message is displayed:

 Enter Packet Control location: [cabinet(1)];carrier(A-B)

If this command is entered for a packet-control that resides on the stand-by 
control complex of a High or Critical Reliability System, the following message is 
displayed:

 Command only applies to the active Packet Control

If during the execution of a command a resource problem occurs that requires 
the user to restart the command, then the following message is displayed:

 Command resources busy; Press CANCEL to clear, and then 

resubmit

If all of the available maintenance resources are currently in use, then the 
following message will be displayed:

 All maintenance resources busy; try again later

location

The location only applies to duplicated configurations. If the 
configuration is a simplex, the location parameter is not used and thus 
is not valid. For duplicated configurations, a "location" represents the 
carrier that the packet-control resides on in the system. Valid locations 
are either 1A or 1B.