Lucent Technologies R5SI User Manual
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Commands and Trouble-Clearing Aids
Page 8-321
reset maintenance
8
reset maintenance
This command will reset the EPN maintenance circuit pack in any Expansion Port
Network cabinet.
Network cabinet.
Synopsis
reset maintenance location
Permissions
The following logins may execute this command: system technician, inads, init.
Examples
reset maintenance 02
reset maintenance 2
reset maintenance 3a
reset maintenance 2
reset maintenance 3a
Description
The reset maintenance command performs a reset on a technician specified
EPN maintenance circuit pack. Specifying cabinets 2 or 3 resets the EPN
maintenance circuit pack in the ’a’ carrier of the specified cabinet.
EPN maintenance circuit pack. Specifying cabinets 2 or 3 resets the EPN
maintenance circuit pack in the ’a’ carrier of the specified cabinet.
This command is destructive and will drop a SAT terminal session on the EPN
maintenance circuit pack being reset. If this command is run from a EPN
maintenance SAT terminal, the results of the reset will not be displayed.
maintenance circuit pack being reset. If this command is run from a EPN
maintenance SAT terminal, the results of the reset will not be displayed.
Defaults
None.
Parameters
Help Messages
If the system technician presses
HELP
after entering "reset maintenance" the
following message will be displayed:
Enter cabinet([0]2-[0]3);[carrier(A)]
location
The location designates the physical position of the desired EPN
maintenance circuit pack. The location consists of a cabinet number
and carrier letter. The cabinet number is one digit, 2 through 3 with a
leading zero allowed. The carrier is always "a" if entered.
maintenance circuit pack. The location consists of a cabinet number
and carrier letter. The cabinet number is one digit, 2 through 3 with a
leading zero allowed. The carrier is always "a" if entered.