Lucent Technologies R5SI User Manual

Issue 1

April 1997

Maintenance Commands and Trouble-Clearing Aids 

Page 8-329

reset system 

If the "health-override" option is specified with any level of 1 - 5, the following 
message will be displayed:

The ’health-override’ option is only used 

with the ’interchange’ level

If the command entered is in conflict with another currently executing command, 
then a message will be displayed showing the login id of the conflicting user and 
the conflicting command. The message is as follows:

’login id’:’command’ has a command conflict

If this command is issued while an 

 command is active the 

following message will be displayed:

Standby SPE upgrade in progress, command denied

If the reset command, including the "reset system interchange," is successful the 
user will be logged off.

If the "reset system interchange" command is not successful one of the following 
are displayed:

If the "interchange" option is specified and the active SPE is locked active, the 
following message will be displayed:

Unable to interchange because the 

active SPE is locked active

If the "interchange" option is specified and only the Fault Severity Level of the 
standby SPE is preventing the interchange, the following message will be 
displayed:

Unable to interchange due to alarms on the standby SPE;

Use ’health-override’ option

If the "interchange" option is specified and the standby SPE is busied out, the 
following message will be displayed:

Unable to interchange; standby SPE is busied out

If the reset interchange command cannot be performed for any other reason, the 
following message will be displayed on the SAT:

Cannot perform SPE interchange; 

for information use ’status system’