Renesas 32186 User Manual
32185/32186/32192/32195/32196 Group
Starter Kit User’s Manual M3A-2154G52B
REJ10B0223-0140/Rev.1.40
Jan. 2007
Page 10 of 79
5. Hardware Setup
This chapter describes how to set up the hardware components necessary to use the Starter Kit.
Table 5.1 and Table 5.2 show how to set up the hardware components.
Table 5.1 and Table 5.2 show how to set up the hardware components.
Table 5.1 Hardware Setup Procedure
Setup Procedure
When connected to the emulator
When using the evaluation
board by itself
Set the emulator
1st (Refer to 5.1.1) —
Connect the host PC and emulator
2nd (Refer to 5.1.1) —
Set the evaluation board
3rd (Refer to 5.1.2)
1st (Refer to 5.3.1)
Connect the evaluation board and
emulator
emulator
4th (Refer to 5.1.3) —
Turn on the emulator
5th (Refer to 5.1.4) —
Turn on the evalution board
6th (Refer to 5.1.4)
2nd (Refer to 5.3.2)
Table 5.2 Hardware Power Off Procedure
Setup Procedure
When connected to the emulator
When using the evaluation
board by itself
Turn off the evaluation board.
1st (Refer to 5.1.4)
1st (Refer to 5.3.2)
Turn off the emulator.
2nd (Refer to 5.1.4) —
5.1 M3A-2154 Evaluation Board Hardware Setup
5.1.1 M32100T-EZ-E Power Supply and Settings
5.1.1 M32100T-EZ-E Power Supply and Settings
The following shows how to set M32100T-EZ-E.
For more details, refer to M32100T-EZ-E User’s Manual.
M32100T-EZ-E is supplied power from the host PC via USB cable, and it turns ON by connecting
included USB cable.
The Connecting M32100T-EZ-E and Host PC is shown in Figure 5.1
For more details, refer to M32100T-EZ-E User’s Manual.
M32100T-EZ-E is supplied power from the host PC via USB cable, and it turns ON by connecting
included USB cable.
The Connecting M32100T-EZ-E and Host PC is shown in Figure 5.1
Figure 5.1 Connecting M32100T-EZ-E and Host PC
USB cable
M32100T-EZ-E
USB I/F
Connect to the host
PC’s USB port
PC’s USB port