Fujitsu FR81S User Manual

Page of 2342
CHAPTER 36: EXTERNAL BUS INTERFACE 
 
 
5. Operation 
 
FUJITSU SEMICONDUCTOR LIMITED 
CHAPTER : EXTERNAL BUS INTERFACE 
FUJITSU SEMICONDUCTOR CONFIDENTIAL 
46 
The above setting values are written to ASR as words. 
The CS area settings are explained below. 
1.  Determine the size of the CS area and select the value of ASZ[3:0] from "4.1 CS Area Setting 
Registers: ASR0 to ASR3 (Area Setting Register 0-3)". 
2.  Set the CS area start address. The starting address is configured by setting the upper bits of the address 
in SADR. However, the starting address has the boundaries determined in advance depending on the 
size of the area specified in the following table. Set the valid bits of SADR according to "4.1 CS 
Area Setting Registers: ASR0 to ASR3 (Area Setting Register 0-3)". Set invalid SADR bits to "0". 
MB91520 Series
MN705-00010-1v0-E
1245