Fujitsu FR81S User Manual
CHAPTER 40: MULTI-FUNCTION SERIAL INTERFACE
6. Operation of CSIO
FUJITSU SEMICONDUCTOR LIMITED
CHAPTER : MULTI-FUNCTION SERIAL INTERFACE
FUJITSU SEMICONDUCTOR CONFIDENTIAL
223
6.2.5. Operation of Serial Timer
The serial timer can be used for either of the timer function or the synchronous transmission function.
How to Start Serial Timer
There are two ways to start the serial timer: setting "1" to the serial timer enable bit (SACSR:TMRE) or
starting by the external trigger.
⋅
Start by using the serial timer enable bit (SACSR:TMRE)
When the external trigger enable bit (SACSR:TRGE) is set to "0" and the serial timer enable bit
(SACSR:TMRE) is set to "1", the serial timer starts and the serial timer register (STMR) starts counting
from 0.
Figure 6-16 Start by Using Serial Timer Enable Bit
(STMCR="10", SACSR:TRGE=TSYNE="0")
10
0
1
2
・・・
9
10
1
0
STMR
STMCR
TINT
TMRE
Serial timer activation
⋅
Start by External Trigger
When the external trigger enable bit (SACSR:TRGE) is set to "1", the serial timer starts and the serial
timer register (STMR) starts counting from 0 if an edge of the external trigger set by the trigger selection
bit (TRG1, 0) is detected while the serial timer enable bit (SACSR:TMRE) is "1".
Figure 6-17 Start by External Trigger
(STMCR="10", SACSR:TRGE="1", TSYNE=TRG1="0")
10
0
1
2
・・・
9
10
1
0
STMR
STMCR
TINT
TMRE
External trigger
Serial timer activation
Note:
When the external trigger enable bit (SAGSR:TRGE) is "1" and the serial timer enable bit (SAGSR:TMRE)
is "0", the serial timer does not operate even if the edge of the external trigger set by the trigger selection bit
(SAGSR:TRG1, 0) is detected.
MB91520 Series
MN705-00010-1v0-E
1536