Fujitsu FR81S User Manual

Page of 2342
CHAPTER 45: FLASH MEMORY 
 
 
5. Operation 
 
FUJITSU SEMICONDUCTOR LIMITED 
CHAPTER : FLASH MEMORY 
FUJITSU SEMICONDUCTOR CONFIDENTIAL 
45 
5.8.  Sector Erase Suspend Command 
The sector erase suspend command is shown below 
The sector erase can temporarily be stopped in the command time-out or while executing the sector erase. 
The reading operation of the memory cell of the sector that is not the erase target becomes possible in the 
suspend condition of the sector erase. However, a new neither writing nor erase command is accepted. 
The sector erase suspend command is sent to an arbitrary address of target FLASH macro to suspend of the 
sector erase. 
After the sector erase stops, the reading operation from target FLASH macro is permitted. 
At this time, the hardware sequence flag is read from the sector which is under the sector erase suspend 
condition. 
  The TOGG1 bit that does the toggle while erasing the sector does not toggle in the sector erase suspend 
condition.   
  FRDY of the flash status register becomes "1". 
The thing that entered the sector erase suspend condition can be confirmed by using these. 
 
Note: 
16.7μs or less is required until the sector erase operation is stopped from the issue of the sector erase 
suspend command and reading from the sector that is not the erase target becomes possible. 
 
Because Bit2:TOGG2 of the hardware sequence flag does the toggle while the sector erase is temporarily 
stopping, the sector can be confirmed while stopping by using this bit. 
To restart the interrupting erase operation from the sector erase suspend condition, the sector erase restart 
command in Table 5-1 is sent. 
The sector erase restart command is accepted only by the sector erase suspend condition. 
Send the command after confirming becoming the sector erase suspend condition.   
Accepting the erase restart command, the flash memory comes back to the sector erase condition, resuming 
the erase operation. 
 
MB91520 Series
MN705-00010-1v0-E
1966