Emerson ATCA-9305 User Manual
Management Processor CPLD:
MPC8548 PLD Register
5-12
Register 5-22:
Cavium 2 C_MULL Clock Divisor Control (0x74)
JTAG
This register allows for manual reprogramming of the PLDs on the board. Changes to this
register do not take effect until after a full board reset.
register do not take effect until after a full board reset.
Register 5-23:
JTAG (0x78)
Cavium GPIO Control
Each Cavium processor has three GPIO control bits connected to the PLD. This register
determines whether the PLD is driving or receiving on these lines. Setting a bit to 1 causes
the PLD to drive the corresponding line.
determines whether the PLD is driving or receiving on these lines. Setting a bit to 1 causes
the PLD to drive the corresponding line.
Register 5-24:
Cavium GPIO Control (0x80)
Bits:
Function:
Description:
7
CAVF1
Cavium 1 Frequency resistor set bit (read-only, see Register
Map 5-21)
Map 5-21)
6
CAVF0
Cavium 0 Frequency resistor set bit (read-only)
5
CMULOE
C_MUL Output Enable
4
P1CMUL4
These bits drive directly to the Cavium 2. The core clock speed
is the number multiplied by 50 MHz. For example, the 800 MHz
core is set to 16(0x10).
is the number multiplied by 50 MHz. For example, the 800 MHz
core is set to 16(0x10).
3
P1CMUL3
2
P1CMUL2
1
P1CMUL1
0
P1CMUL0
Bits:
Function:
Description:
7
reserved
6
reserved
5
JTAGOEN
JTAG Output Enable
4
JTAGTCKSEL
JTAG Test Clock Select changes from header to PLD as the TCK
source
source
3
JTAGTCK
JTAG Test Clock
2
JTAGTMS
JTAG Test Mode Select
1
JTAGTDO
JTAG Test Data Output
0
JTAGTDI
JTAG Test Data Input (read only)
Bits:
Function:
Description:
7
reserved
6
reserved
5
P2GPIO5OE
Processor 2 GPIO5 Output Enable (enabled is the default)
Output enable is set for the TIC timer output to the Cavium
Output enable is set for the TIC timer output to the Cavium
4
P2GPIO4OE
Processor 2 GPIO4 Output Enable
This is an input from the Cavium to reset the MIP4
This is an input from the Cavium to reset the MIP4