Gateway ALR 9200 User Manual
4 Maintaining and Troubleshooting the Gateway ALR 9200 Server
5.
Remove and save the three screws from the back of the access cover
(see Figure 1); you will need them later to reattach the cover.
(see Figure 1); you will need them later to reattach the cover.
Figure 1: Removing the Access Cover
6.
Place the fingertips of your right hand under the built-in handle on the
back of the cover. A rounded, rectangular depression in the front
middle of the access cover serves as another handle.
back of the cover. A rounded, rectangular depression in the front
middle of the access cover serves as another handle.
7.
Using an even pull, slide the cover backward, about an inch, until it
stops.
stops.
8.
Pull the entire cover outward, straight away from the chassis, to
disengage the rows of tabs from the notches in the top and bottom
edges of the chassis. Set the cover aside.
disengage the rows of tabs from the notches in the top and bottom
edges of the chassis. Set the cover aside.
Opening the Front Door
The front door is secured to the bezel by a key lock. This lock has three
positions: fully locked, front door unlocked, and front and access cover
unlocked. When the front door is unlocked, you can remove it by opening it
fully and lifting the hinges out of the slots that hold them.
positions: fully locked, front door unlocked, and front and access cover
unlocked. When the front door is unlocked, you can remove it by opening it
fully and lifting the hinges out of the slots that hold them.
3424.boo Page 4 Wednesday, September 2, 1998 9:23 AM