Gateway ALR 9200 User Manual

•

Have any of the fan motors stopped (use the server management 
subsystem to check the fan status)?

•

Are the fan power connectors properly connected to the system 
board?

•

Is the cable from the front panel board connected to the system 
board?

•

Are the power supply cables properly connected to the system 
board?

•

Are there any shorted wires caused by pinched cables or power 
connector plugs forced into power connector sockets the wrong 
way?

If the switches and connections are correct and AC power is available at the 
wall outlet, contact Technical Support for assistance.

Diskette Drive Activity Light Does Not Light

Check the following:

•

Are the diskette drive power and signal cables properly installed?

•

Are all relevant switches and jumpers on the diskette drive set 
correctly?

•

Is the diskette drive properly configured?

•

Is the diskette drive activity light always on? If so, the signal cable 
may be plugged in incorrectly.

If you are using the onboard diskette controller, use the SSU to make sure 
that 

 is set to 

 If you are using an add-in diskette 

controller, make sure that 

 is set to 

 To run the SSU, 

see “Using the System Setup Utility” on page 105.

If the problem persists, there may be a problem with the diskette drive, 
system board, or drive signal cable. Contact your service representative or 
authorized dealer for assistance.

3424.boo  Page 167  Wednesday, September 2, 1998  9:23 AM