Advantech MIC-3043 User Manual
11
Chapter 2
To remove a card:
1.
1.
Unscrew the screws on the card front panel. Release the locking
latches on the handles.
latches on the handles.
2.
Lift the upper handle up and press the lower handle down to release
the card from the backplane.
the card from the backplane.
3.
Slide the card out.
2.3.2 Before Operating the System
Before operating your system, first check your power supply source.
Adjust the switch on the power supply to the correct voltage.
Two mounting flanges are included for users who would like to install the
MIC-3043 on a 19" rack.
Adjust the switch on the power supply to the correct voltage.
Two mounting flanges are included for users who would like to install the
MIC-3043 on a 19" rack.
2.3.3 Installing a 3.5" Hard Disk Drive
Follow these procedures to install 3.5" hard disk drives in the MIC-3043:
1.
1.
Open the disk tray door and remove the mobile rack. For a SCSI
version, the SCSI ID is shown on the mobile rack panel. This is the
same ID that the SCSI control would find after system startup.
version, the SCSI ID is shown on the mobile rack panel. This is the
same ID that the SCSI control would find after system startup.
2.
Mount the HDD (SCSI/IDE/SATA) on the mobile rack with
screws.
screws.
3.
Slide the HDD with mobile rack back into the tray.
4.
Power on the system and check that the HDD can be found at the
SCSI initialization.
SCSI initialization.
Note:
(1) The SCSI version (MIC-3043C) must be
used with a RIO module that has a SCSI con-
troller, like RIO-3309S-A.
(2) The SCSI ID is assigned by the internal
SCSI adaptor of MIC-3043, #0 and #1 are
fixed and cannot be changed. Users can read
the number on the disk mobile rack..
used with a RIO module that has a SCSI con-
troller, like RIO-3309S-A.
(2) The SCSI ID is assigned by the internal
SCSI adaptor of MIC-3043, #0 and #1 are
fixed and cannot be changed. Users can read
the number on the disk mobile rack..