Advantech AIMB-760 User Manual

This item allows you to enable/disable IR transmission delay. The 
choices are “Enabled” and “Disabled”.

This item allows you to select the IR half/full duplex function. The 
choices are “Half” and “Full”.

The choices are “RxD2, TxD2” and “IR-Rx2Tx2”.

This field sets the address of the on-board parallel port connector. You 
can select “378/IRQ7”, “278/IRQ5”, “3BC/IRQ7”, or “Disabled”. If you 
install an I/O card with a parallel port, make sure there is no conflict in 
the address assignments. The single board computer can support up to 
three parallel ports.

This field allows you to set the operation mode of the parallel port. The 
setting “Normal” allows normal speed operation, but in one direction 
only. “EPP” allows bidirectional parallel port operation at maximum 
speed. “ECP” allows the parallel port to operate in bidirectional mode and 
at a speed faster than the maximum data transfer rate. “ECP + EPP” 
allows normal speed operation in a two-way mode.

This field allows you to select EPP port type 1.7 or 1.9. The choices are 
“EPP1.9” and “EPP1.7”.

This selection is available only if you select “ECP” or “ECP + EPP” in 
the Parallel Port Mode field. In ECP Mode, you can select DMA channel 
1 or DMA channel 3. Leave this field on the default setting.