AMD N2PAP-LITE User Manual
6
Chapter 2
Hardware Installation
2-1 Hardware installation Steps
When installing the system, make sure to follow steps described in below:
1. Check motherboard setting
2. Install CPU
3. Install memory
4. Install expansion cards
5. Connect ribbon cables, panel wires, and power supply
6. Setup BIOS
7. Install software driver & utility
1. Check motherboard setting
2. Install CPU
3. Install memory
4. Install expansion cards
5. Connect ribbon cables, panel wires, and power supply
6. Setup BIOS
7. Install software driver & utility
2-2 Checking Motherboard’s Jumper Setting
(1) Keyboard Power On function Enabled/Disabled: JP1
USB Wake-Up function Enabled/Disabled : JP4
When set as Enabled you can use keyboard to power on the system by password key-
in, and use USB device to wake up the system.
in, and use USB device to wake up the system.
JP4 1-2 closed USB Power On Disabled (Default)
JP1 1-2 closed K/B Power On Disabled (Default)
JP4
1
3
JP4
1
3
JP4 2-3 closed USB Power On Enabled
JP1 2-3 closed K/B Power On Enabled
JP1
3
1
JP1
3
1
(2) CPU Front Side Bus Frequency Setting (2-pin) : JP2
CPU Front Side Bus Frequency
ON : (AUTO)
JP2
1
2
OFF : 100MHz
JP2
1
2