AMCC 9590SE-4ME User Manual

Chapter 2. CLI Syntax Reference

46

/c

x

 add verify=

ddd:hh:duration

This command adds a new background verify task to be executed on the day 
ddd (where ddd is Sun, Mon, Tue, Wed, Thu, Fri, and Sat), at hour hh 
(range 0 .. 23), for a duration of duration (range 1 .. 24) hours. A maximum of 
seven verify tasks can be scheduled. This command will fail if no (empty) 
task slot is available. 

 //localhost> /c1 add verify=Sun:16:3

adds a verify background task schedule to be executed on Sundays at  16 
hours (4:00 PM) for a duration of 3 hours.

Setting up a verify schedule requires several steps, and several different CLI 
commands in addition to /cx add verify.

1

Use the /cx show verify command to display the current schedule for 
verify tasks. (For details, see page 43.)

2

If any of the scheduled tasks do not match your desired schedule, use
the /cx del verify command to remove them. (For details, see page 48.)

3

Use the /cx add verify command to create the verify schedule slots you 
want (described above.)

4

Use  the /cx set verify=enable command to enable the schedule (this 
enables all rebuild schedule slots). (For details, see page 49.)

5

Use  the /cx/ux set autoverify=on command to turn on autoverify for each 
unit you want to follow the schedule. (For details, see page 61.)

                                      

                                      

If you do not enable autoverify for units or start a verification manually, your 

verify schedule will not run, even if it is enabled with the 
/cx set verify=enable command.

 If all time slots are removed, be sure to also disable the schedule. 

Otherwise the applicable background task will never occur