AMCC 9590SE-4ME User Manual

Enclosure Object Commands

79

Enclosure Object Commands

Enclosure object commands provide information and perform actions related 
to a specific enclosure, such as /e0 and its elements, such as /e0/slot0. 
Enclosure object elements include slot, fan, and temperature sensor elements.

These commands support the 9550SX and 9590SE controllers. If you 
purchased an enclosure directly from a third-party vendor, the appropriate 
EPCT (Enclosure Port Configuration Table) must have been downloaded to 
the controller in order to take advantage of these commands. 

If you have a 3ware Sidecar Kit for use with a Power Mac G5, the required 
EPCT file is already installed.

/ex show                          (9550SX and 9590SE only)

/ex show attribute [attribute ...] where attributes are:

controllers|slots|fans|temp

/ex show all                      (9550SX and 9590SE only)

/ex/slotx show                    (9550SX and 9590SE only)

/ex/slotx show identify           (9550SX and 9590SE only)

/ex/slotx set identify=on|off     (9550SX and 9590SE only)

/ex/fanx show                     (9550SX and 9590SE only)

/ex/tempx show                    (9550SX and 9590SE only)

/e

x

 show

This command shows summary information on the specified enclosure /ex. 
This report consists of four parts; the Enclosure summary listing the present 
elements, a Fan summary section listing of all present fans, a Temperature 
Sensor summary section listing of all present temperature sensors and a Slot 
summary section listing of slots and associated information for the specified 
enclosure. 

Typical output looks like:

 //localhost> /e0 show

 Encl        Controllers

 -------------------------

 e0          /c0

 Fan       Status          

 ----------------------

 fan0      OK