Alesis NANOVERB-2 Quick Setup Guide

  

 

 
1. 

Make sure all items listed in the Box Contents are included. 

2. 

3. 

Place the product in an appropriate location for operation. 

4. 

Ensure high quality, shielded audio cables are used away from 
sources of electromagnetic interference.  

 
 
 
 

 

 

5

1

2

3

4

6

7

– Light will illuminate once the unit is powered on 

– Controls both the Left (Mono) and Right channel analog input signal level 

– LED will light up if the signal level is too high which may cause distortion. If this occurs, turn 

down the Input control knob and/or reduce the output level from your instrument source 

– Adjusts the analog output signal level 

– Adjusts the balance between the incoming "dry" signal and the

 

effect-processed signal. When this knob is 

turned to the far left, no processed signal will be heard. When the knob is turned to the middle position, an equal 
mix of the dry and processed signal will be heard. When the knob is turned to the far right, only the processed 
signal will be heard 

– Select one of the 16 factory presets with this knob 

– This will switch between different variations of the effect 

 

 

 

8

9

9

10 10

11

 

 
8. POWER 

CONNECTOR – Plug the included AC adapter here (9v AC 500mA) 

9. INPUT – Connect the ¼” unbalanced inputs to your source, such as Aux Sends on a mixer. For mono sources, 

just connect to the Left (Mono) input on the NANOVERB 2  

10. OUTPUT – Connect the ¼” unbalanced outputs to an Aux Return on a mixer, powered speakers, or amplifer 

input 

11. BYPASS – Attach a momentary (non-latching) footswitch to this 1/4" phone jack. When the footswitch is pressed, 

the NANOVERB 2 will bypass the effects and only the dry signal will pass through the unit. If the footswitch is 
pressed again, effects will continue to output 

 
 
 
 

BOX CONTENTS 
ƒ NANOVERB 

2 

ƒ Power 

Adapter 

ƒ Quickstart 

Guide 

ƒ Safety 

Instructions 

& 

Warranty Information 
Booklet